Siemens Gigaset S450IP User Manual download pdf (Page 8)

7

First steps

Gigaset S450 IP KBA / EN US / A31008-M1713-R321-2-6043 / starting.fm / 17.1.07

Version 4, 16.09.2005

Initial charging and discharging of

batteries

Battery charging is indicated in the top

right of the display by a flashing battery

icon e, V or U. During handset oper-

ation, the battery icon indicates the

charge status of the batteries (page 1).

The correct charge status can only be dis-

played when the batteries are first fully

charged and discharged through use.

¤ To do this, leave the handset in the

charging cradle without interruption

until the battery icon stops flashing in

the display (approx. 13 hours).

¤ Once the batteries are fully charged,

remove the handset from the charging

cradle and do not put it back again until

the batteries are fully discharged.

Please note:

u Always repeat the charging and dis-

charging procedure if you remove the

batteries from the handset and reinsert

them.

u The batteries may warm up as they are

charging. This is not dangerous.

u After a while the charge capacity of the

batteries will decrease for technical rea-

sons.

Setting the date and time

If the date and time are not yet set on the

phone, the display key

§Time§ is displayed.

You can set the date and time later via the

menu v

¢ Ð Settings ¢ Date/Time.

¤ Press §Time§ or open the menu.

¤ Change multiple line input:

Date:

Enter month, day and year in 6-digit

format.

Time:

Enter hours and minutes as 4 digits

(e.g. Q M 1 5 for 07:15 am

If you have selected the 12-hour time for-

mat, use the display key

§am/pm§ to switch

between am and pm.

Time Mode:

Choose between 12 and 24-hour time

format.

§Save§ Press the display key.

The date and time are shown in the hand-

set's idle display (page 1).

Area codes

In order to call back a caller using the calls

list (page 20), your phone's area code

("local area code") must be stored. If your

phone is in a "multiple area code" area, the

extra codes for this area must also be

stored.

Area Code

v ¢ Ð Settings ¢ Telephony

¢ Area Code

~ Enter local area code.

§Save§ Press the display key.

a Press and hold (idle status).

Extra Codes

v ¢ Ð Settings ¢ Telephony

¢ Extra Codes

q Select an entry and press §Edit§.

~ Enter extra code.

§Save§ Press the display key.

Note:

After the first battery charge and discharge,

you may replace your handset in the charging

cradle after every call.

Note:

You will find explanations of the icons and

typographical conventions used in this user

guide in the detailed user guide for your

Gigaset S450 IP available online at

www.siemens.com/gigaset

.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 43 44

Comments to this Manuals

No comments