Siemens Gigaset S450IP User Manual download pdf (Page 30)

29

Appendix

Gigaset S450 IP KBA / EN US / A31008-M1713-R321-2-6043 / appendix.fm / 17.1.07

Version 4, 16.09.2005

General specifications

FCC / ACTA Information

Warning: Changes or modifications to this unit

not expressly approved by Siemens Cordless

Products could void the FCC authority to oper-

ate the equipment. This includes the addition of

any external antenna device.

This equipment complies with Part 68 of the

FCC rules and the requirements adopted by the

ACTA. On the bottom of the base station is a

label that contains, among other information,

a product identifier in the format

US:AAAEQ##TXXXX. If requested, this number

must be provided to the telephone company.

A plug and jack used to connect this equipment

to the premises wiring and telephone network

nust comply with the applicable FCC Part 68

rules and requirements adopted by the ACTA.

A compliant telephone cord and modular plug

is provided with this product. It is designed to

be connected to a compatible modular jack that

is also compliant. See installation instructions

for details.

The REN is used to determine the number of

devices that may be connected to a telephone

line. Excessive RENs on a telephone line may

result in the devices not ringing in response to

an incoming call. In most but not all areas, the

sum of RENs should not exceed five (5.0). To be

certain of the number of devices that may be

connected to a line, as determined by the total

RENs, contact the local telephone company.

For products approved after July 23, 2001, the

REN for this product is part of the product iden-

tifier that has the format US:AAAEQ##TXXXX.

The digits represented by ## are the REN with-

out a decimal point (e.g., 03 is a REN of 0.3).

For earlier products, the REN is separately

shown on the label.

If this equipment causes harm to the telephone

network, the telephone company will notify you

in advance, that temporary discontinuance of

service may be required. But if advance notice

isn’t practical, the telephone company will

notify the customer as soon as possible. Also,

you will be advised of your right to file a com-

plaint with the FCC if you belive it is necessary.

The telephone company may make changes in

its facilities, equipment, operations or proce-

dures that could affect the operation of the

equipment. If this happens the telephone com-

pany will provide advance notice in order for

you to make necessary modifications to main-

tain uninterrupted service. If you experience

trouble with this telephone system, disconnect

it from the network until the problem has been

Interfaces Fixed network, Ethernet

No. of channels 60 duplex channels

Radio frequency-

range

1880–1900 MHz

Duplex method Time multiplex,

10 ms frame length

Channel grid 1728 kHz

Bit rate 1152 kbit/s

Modulation GFSK

Language code 32 kbit/s

Transmission

power

10 mW, average power per

channel

Range up to 328 yards outdoors,

up to 55 yards indoors

Base station

power supply

230 V ~/50 Hz

Environmental

conditions in oper-

ation

+41°F to +113°F;

20% to 75% humidity

Dialing mode DTMF (touch tone dialing)/

DP (dial pulsing)

Flashing time 250 ms

Codecs G711, G726, G729AB with

VAD/CNG

Quality of Service TOS, DiffServ

Proto cols DE CT, GA P, SIP, R TP, DH CP,

NAT Traversal (STUN),

HTTP

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 43 44

Comments to this Manuals

No comments