Siemens SINUMERIK 802D sl Operator's Manual download pdf (Page 254)

Overview of alarms 06/2009

Cycle alarms

2-254

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61607 [Channel %1: ] Block %2: Starting point incorrectly programmed

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The starting point reached before the cycle call does not lie outside the rectangle described by the

contour subroutine. Alarm triggered by following cycle: CYCLE95.

Remedy: Check starting point prior to cycle call.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61608 [Channel %1: ] Block %2: Incorrect tool point direction programmed

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Alarm triggered by following cycles: CYCLE94, CYCLE96.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: A cutting edge position 1...4, matching the undercut form, must be programmed.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61609 [Channel %1: ] Block %2: Shape incorrectly defined

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Alarm triggered by following cycles: CYCLE94, CYCLE96, LONGHOLE, POCKET3, SLOT1.

Remedy: Check parameter for the undercut form or groove form or pocket.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61610 [Channel %1: ] Block %2: No infeed depth programmed

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Alarm triggered by following cycles: CYCLE76, CYCLE77, CYCLE96.

Remedy: Check parameter MID.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61611 [Channel %1: ] Block %2: No point of intersection found

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: No intersection could be calculated with the contour. Alarm triggered by following cycle: CYCLE95.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Check contour programming or modify infeed depth.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61612 [Channel %1: ] Block %2: Thread finishing not possible

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Alarm triggered by following cycles: CYCLE97, CYCLE98.

Remedy: Check the conditions for thread finishing.

1 2 ... 249 250 251 252 253 254 255 256 257 258 259 ... 339 340

Comments to this Manuals

No comments

Siemens SINUMERIK 802D sl Operator's Manual Page 254

Comments to this Manuals

Related products and manuals for Security access control systems Siemens SINUMERIK 802D sl