Siemens CU230P-2 Service Manual Page 7
- Page / 732
- Table of contents
- BOOKMARKS
- SINAMICS 1
- SINAMICS G120 3
- Control Units CU230P-2 3
- Contents 5
- Parameters 1 7
- Fig. 1-1 Read-only parameter 8
- Fig. 1-2 Write parameter 8
- CoBo.pdf 9
- Introduction to Parameters 14
- 1.2 List of Parameters 17
- [6] = Total U, V, W 36
- [4] = Phase V offset 36
- Parameters 100
- List of Parameters 100
- Yes No 225
- 1.3.1 Command Data Sets (CDS) 470
- 1.3.2 Drive Data Sets (DDS) 472
- 1.3.3 Motor Data Sets (MDS) 477
- Function diagrams 2 493
- Function diagrams 500
- 2.3 Overview 504
- 505
- ... ... 505
- Overview 506
- 2.4 Input/Output Terminals 512
- Input/Output Terminals 513
- % 100x • 519
- 2.5 Communication 520
- Communication 522
- 2.5.3 CANopen (CU230P-2 CAN) 542
- Internal control/status words 550
- 2.7 Setpoint channel 567
- Setpoint channel 568
- 2.8 V/f control 577
- V/f control 578
- 2.9 Vector control 581
- Vector control 582
- Upper torque limit 590
- Lower torque limit 590
- 2.10 Free Function Blocks 601
- Free Function Blocks 602
- 2.11 Technology functions 622
- Technology functions 623
- 2.12 Technology controller 630
- Technology controller 631
- 2.14 Faults and warnings 645
- Faults and warnings 646
- 2.15 Data sets 650
- Data sets 651
- Faults and Alarms 3 653
- 3.1.1 General information 654
- Faults and Alarms – Overview 655
- Faults and Alarms 655
- 3.1.2 Fault reactions 656
- 3.2 List of Faults and Alarms 658
- List of Faults and Alarms 663
- Appendix A 715
- A.1 ASCII Table (excerpt) 716
- A.2 List for motor code 716
- List of Abbreviations B 717
- List of Abbreviations 718
Related products and manuals for Power generators Siemens CU230P-2
(129 pages)
(67 pages)
© 2020, manymanuals.com. All rights reserved. | 0.059 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals