Siemens Gigaset C34 User Manual download pdf (Page 6)

5

Setting up the telephone for use

Gigaset C34 / ISR eng / A31008-M1607-B501-1-7619 / start_guide_time.fm / 22.3.05

is happening, Registering appears in the

display and the name of the base, Base 1,

flashes.

When the handset has registered, its

screen displays its internal number, e.g.

INT 2 for internal number 2. The handset is

assigned the lowest available internal

number (1-6). If all internal numbers 1–6

have been assigned, number 6 is overwrit-

ten if the handset with internal number 6

is in idle status.

Manual registration Gigaset C34

If the handset does not activate automati-

cally when the batteries are fitted, you

must first charge the batteries.

You must activate manual registration of

the handset at both the handset and the

base station.

After it has registered, the handset returns

to idle status. The internal number of the

handset appears in the display, e.g. INT 2.

Otherwise repeat the procedure.

1. On the handset

Menu§ ¢ Handset ¢ Handset ¢ Register

Handset

~ Enter the system PIN of the

base (the default is 0000) and

press

§OK§. You will see, e.g.

Registering Base 1 flashing in

the display.

2. On the base

¤ Initiate registration on the base station

within 60 seconds as described in the

base unit's instructions.

Charging batteries

¤ Plug the mains unit of the charging cra-

dle into a mains power socket.

¤ Place the handset in the cradle with its

display facing forward.

Battery charging is indicated in the top

right of the display by a flashing battery

icon e, V or U. During handset oper-

ation, the battery icon indicates the

charge status of the batteries (page 1).

First battery charge and discharge

The correct charge status can only be dis-

played when the batteries are first fully

charged and discharged through use.

¤ To do this, leave the handset in the

charging cradle without interruption

until the battery icon stops flashing in

the display (approx. 6h). Your handset

need not be switched on for it to

charge.

¤ Once the batteries are fully charged,

remove the handset from the cradle

and do not put it back again until the

batteries are fully discharged.

Note:

– Automatic registration is not possible when

the base on which you wish to register the

handset is being used to make a call.

– A key press cancels automatic registration.

– If automatic registration does not work the

handset will have to be registered manually

(page 5).

Note:

– The handset should only be placed in a

base or charging cradle that is designed for

it.

– When the handset is in the cradle, it

charges even if it is switched off.

– If the handset has switched itself off

because the batteries are flat and if it is

then placed in the cradle, it will switch itself

on automatically.

– After the first battery charge and discharge

you may replace your handset in the charg-

ing cradle after every call.

1 2 3 4 5 6 7 8 9 10 11 ... 22 23

Comments to this Manuals

No comments