Siemens CM300/3 User Manual download pdf (Page 27)

4. Clear Text Display Module & System Parameters English

05.02.01

Parameter Function Range

[Default]

Description / Notes

P123

Enable/disable JOG button 0 - 1

[1]

0 = JOG button disabled.

1 = JOG button enabled (only possible if P007 = 1).

P124

Enable/disable ∆ and ∇ buttons

0 - 1

[1]

0 = ∆ and ∇ buttons disabled.

1 = ∆ and ∇ buttons enabled (only possible if P007 = 1).

Note: This applies for frequency adjustment only. The buttons can

still be used to change parameter values.

P125

Reverse direction inhibit 0 - 1

[1]

0 = Reverse direction disabled. Inhibits reverse commands from

ALL sources (reverse RUN commands result in forward rotation)

1 = Normal operation (FORWARD/REVERSE operation allowed)

P131

Frequency setpoint (Hz)

0.00 -120.00

[-]

P132

Motor current (A)

0.0 - 99.9

[-]

P134

DC link voltage (V)

0 - 1000

[-]

P135

Motor RPM

0 - 40000

[-]

P137

Output voltage (V)

0 - 1000

[-]

P140

Most recent fault code 0 - 9999

[-]

The last recorded fault code (see section 5) is stored in this

parameter. It is cleared when the inverter is reset.

This is a copy of the code stored in P930.

P141

Most recent fault code -1 0 - 9999

[-]

This parameter stores the last recorded fault code prior to that stored

in P140/P930.

P142

Most recent fault code -2 0 - 9999

[-]

This parameter stores the last recorded fault code prior to that stored

in P141.

P143

Most recent fault code -3 0 - 9999

[-]

This parameter stores the last recorded fault code prior to that stored

in P142.

P151 •

••

•

Green LED function 0 - 5

[4]

0 =Off

1 =On

2 = Fault mode: On = Tripped

Flashing = Warning

3 = Running mode:On = Motor running

Flashing = Inverter on but motor

stationary

4 = Default mode (see table in section 3.6)

5 = Not used

P152 •

••

•

Yellow LED function 0 - 5

[5]

0 =Off

1 =On

2 = Fault mode: On = Tripped

Flashing = Warning

3 = Running mode:On = Motor running

Flashing = Inverter on but motor

stationary

4 = Not used

5 = Default mode (see table in section 3.6)

P201

PI closed loop mode 0 - 2

[0]

0 = Normal operation (closed loop control disabled).

1 = Not used

2 = Closed loop control using PI input for transducer feedback.

P202 •

••

•

P gain (%) 0.0 - 999.9

[1.0]

Proportional gain.

Read-only parameters. These are copies of the values selected

by P001 but can be accessed directly via the serial link.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 39 40

Comments to this Manuals

No comments

Siemens CM300/3 User Manual Page 27

Comments to this Manuals

Related products and manuals for Power adapters & inverters Siemens CM300/3