Siemens 5890 User's Guide download pdf (Page 120)

SpeedStream Router User Guide

Appendix E:

Step-by-Step Virtual WAN Configuration

There are several steps to configuring a virtual WAN connection. To make it easier to follow, this section

presents the steps that are detailed in 5: Customizing Router Settings | WAN Interface Configuration

Wizard | Add a New Virtual Connection (VC) on page 31.

Shaded rows indicate that these steps are repeated if you select multiple PPPoE sessions to configure in

the PPPoE Session Count window.

Step On this window: Do this:

Web Management

Interface

On the main menu, click Setup, then click WAN Interface.

Current Configuration

At the bottom left corner of the window, click Add a new VC.

Note If the ATM Settings window displays next, click Next to continue to

the Protocol Selection window.

Protocol Selection Select protocol: RFC-2684 Bridged, Bridged with IP, or Routed; PPPoA;

PPPoE.

This step is dependent on your choice of protocol. Click the protocol type to jump to the specific

configuration procedures.

4a RFC-2684 Bridged protocol

4b RFC-2684 Bridged/IP protocol

4c RFC-2684 Routed protocol

4d PPPoE protocol

4e PPPoA protocol

4a. If you selected the RFC-2684 Bridged protocol:

Step On this window: Do this:

Connection Name Enter connection name

VC Wizard Finish

4b. If you selected the RFC-2684 Bridged/IP protocol:

Step On this window: Do this:

2684 Bridged Enter Internet Protocol information as provided by your service provider.

2684 PPPoE Specify if connection will also use PPPoE.

Interface Options Select interface options: firewall, attack detection system, universal plug

and play; RIP; NAT/NAPT.

Connection Name Enter name to use for this connection.

110

1 2 ... 115 116 117 118 119 120 121 122 123 124 125 ... 128 129

No comments

Siemens 5890 User's Guide Page 120