Siemens Gigaset SL565 User Manual download pdf (Page 57)

56

Appendix

Gigaset SL565 / GBR PTT / A31008-M1715-L111-2-7619 / appendix.fm / 11.7.07

Appendix

Care

Wipe the base station, charging cradle and

handset with a damp cloth (do not use

solvent) or an antistatic cloth.

Never use a dry cloth. This can cause

static.

Contact with liquid

If the handset has come into contact with

liquid:

1. Switch off the handset and remove

the battery pack immediately.

2. Allow the liquid to drain from the hand-

set.

3. Pat all parts dry, then place the handset

with the battery compartment open

and the keypad facing down in a dry,

warm place for at least 72 hours (not

in a microwave, oven etc.).

4. Do not switch on the handset again

until it is completely dry.

When it has fully dried out, you will nor-

mally be able to use it again.

Questions and answers

If you have any queries about the use of

your telephone, you can contact us at any

time at

www.siemens.com/gigasetcustomercare

.

The table below contains a list of common

problems and possible solutions.

!

The display is blank.

1. The handset is not switched on.

¥ Press and hold the end call key a.

2. The battery pack is flat.

¥ Charge/replace the battery pack

(page 8).

The handset does not respond to a key press.

The keypad lock is activated.

¥ Press and hold the hash key

#

(page 14).

"Base station x" is flashing in the display.

1. The handset is outside the range of the base

station.

¥ Reduce the distance between handset/

base station.

The base station's range is reduced because

eco mode is activated.

¥ Deactivate eco mode (page 16) or

reduce the distance between the hand-

set and the base station.

2. The handset has been de-registered.

¥ Register the handset (page 40).

3. The base station is not switched on.

¥ Check the base station mains adapter

(page 6).

Base Search is flashing in the display.

The handset is set for Best Base and no base sta-

tion is switched on or within range.

¥ Reduce the distance between handset/base

station.

¥ Check the base station mains adapter

(page 6).

Handset does not ring.

1. The ringtone is switched off.

¥ Activate the ringtone (page 46).

2. Call diversion set to All Calls.

¥ Switch off Call Diversion (page 17).

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 71 72

Comments to this Manuals

No comments