Siemens CP 343-1 User Manual download pdf (Page 7)

1 Properties / Services

B3L−7

CP 343-1 Lean for Industrial Ethernet / Manual Part B3L

Release 03/2007

C79000-G8976-C198-04

Configuration

It is possible to download the configuration data to the CP over MPI or

LAN/Industrial Ethernet. You require STEP 7 with NCM S7 for Industrial Ethernet

(NCM IE) with the following version:

Table 1-1

Version STEP 7 / NCM IE Functions of the CP

V5.2 or higher The range of functions of the CP 343−1 Lean (CX00) can be

configured.

V5.4 or higher Requirement for configuring the full functionality of the

CP 343−1 Lean (CX10 with firmware V1.0) including PROFINET

IO.

V5.4 Service Pack 2 *) Requirement for configuring the full functionality of the

CP 343−1 Lean (CX10 with firmware V2.0) including Web

diagnostics.

*) To use the CP with V5.4 Service Pack 1, you will need to install Hotfix 2, the corresponding hardware

update and a block setup. You will find more information at the following Internet page:

http://www4.ad.siemens.de/WW/news/en/24463868

Programming − Using Blocks

For some communications services, there are pre-programmed blocks (FCs/FBs)

available as the interface in your STEP 7 user program.

You will find a detailed description of these blocks in the NCM S7 for Ethernet

manuals.

Notice

We recommend that you always use the latest block versions for all module types.

You will find information on the latest block version and links to download the

current blocks in our Customer Support area on the Internet:

http://www4.ad.siemens.de/WW/news/en/8797900

If you are using older block types, this recommendation only applies if you also

have the latest firmware version.

You will find further information and Internet addresses in the Preface of the

General Part of this manual.

1 2 3 4 5 6 7 8 9 10 11 12 ... 55 56

No comments

Siemens CP 343-1 User Manual Page 7