Siemens MC35 Specifications download pdf (Page 10)

AT Command Set

MC35_ATC_01_V05.00 Page 10 of 256 15.07.2002

SIM card (ME returns OK or ERROR depending on

setting of AT^SM20).

Statement about sending e-mails via SMS corrected:

If not recognized by provider, @ may be replaced with

“*”.

5.10 149 AT+CNMI Notes regarding AT^SSCONF and AT^SMGO added.

Note regarding the handling of Class 0 short mes-

sages added.

5.11 152 AT+CPMS <mem3> now offers the choice between “MT” and

“SM”

<mem1>, <mem2> and <mem3> are now stored non-

volatile.

Added notes on handling <mem3>.

6.1.7 172 AT+CGSMS Modified parameter <service>=2 (GPRS preferred):

No SMS via GPRS during a circuit switched call.

6.1.8 173 AT^SGAUTH Notes added: Parameter cannot be stored with

AT&W. Default value after power-up is <auth>=3

(PAP and CHAP).

6.3.2 176 ATH Notes on deactivation of PDP context and GPRS con-

nection removed.

8.2

186f

AT^MONI

Response example b): Parameter C1 corrected.

<chann> and <rs> explained in greater detail

References for 3GPP TS 05.05 and 05.08 added

Notes modified:

If the radio cell changes during a connection, the pa-

rameters PWR and RXLev of the ‘Serving Cell’ part

will not be updated, and updating the Cell ID takes 1

or 2 seconds.

8.3 188 AT^MONP <chann> and <rs> explained in greater detail

Notes modified: During a connection new neighbour

cells can be added, but their parameters C1 and C2

will be updated after the call.

8.15 202 AT^SMGO Added note: Indication of URC requires

AT+CNMI=3,1. SMS indication during data transfer

via Break (100ms)

8.19 - 8.28 205 - 212 AT^SNF… All Chapters revised.

8.25 210 AT^SNFPT New AT command: Call progress tones

8.37 222 AT^SRTC New AT command: Select, query, test ringing tones

8.38 224 AT^SSCONF New AT command: Configuring recipient address pa-

rameters in SMS result codes and in +CDS URCs.

9.1.3 231 CMS errors Note and example added: Mapping of CME and CMS

errors if SIM PIN authentication has not been done.

9.1.4 234 URCs Added: URCs will be output after command execution.

Added list of Fax Class 2 URCs.

9.1.5 237 Result codes Removed 3 result codes “CONNECT…”, and pre-

served those wich include “CONNECT …/RLP”

Added to List of PIN1 requiring AT commands:

AT+CPIN2, AT^SSDA

9.3 248f Added to List of PIN1 independent AT commands:

AT+VTS, AT^SNFPT, AT^SRTC, AT^SSCONF

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 255 256

Comments to this Manuals

No comments

Siemens MC35 Specifications Page 10

Comments to this Manuals