Siemens 680 User Manual download pdf (Page 13)

- 12 -

Operation

Trouble Shooting

TROUBLE POSSIBLE CAUSES CORRECTION

Open stator windings. Disconnect motor from load. Check idle amps

for balance in all three phases. Check stator

resistance in all three phases for balance.

Air Recirculation. Check air intake and exhaust for obstructions.

Check air inlet temperature.

Over voltage/under voltage. Check voltage and compare to rating plate.

Ground. Locate with test lamp or insulation tester and

repair.

Improper electrical connections. Recheck electrical connections.

Heat exchanger tubes blocked. Clean tubes, if so equipped.

Motor overheating

(continued…)

Loose heat exchanger tubes. If so equipped, Roll tubes to expand tube

inside diameter using proper expansion tool.

Fine dust under coupling

having rubber buffers or

pins.

Misalignment. Realign motor and driven equipment.

Inspect coupling.

Oil level too high or low (sleeve bearing).

Correct oil level. See Maintenance section of

this instruction book to determine proper oil

level.

Misalignment. Realign motor and driven equipment.

Excessive tension in belt drive. Reduce tension to point of adequacy.

Excessive end thrust. Reduce thrust. Recheck mounting and

alignment.

Too much grease (ball or roller bearing). Relieve supply to point set by manufacturer.

Bearing overheating.

Sticking oil ring (sleeve bearing). Clean, repair, or replace. Recheck mounting.

Parts not sealed properly. Seal pipe plugs and connections.

Seal bearing housing split line.

Seal oil seal joint.

Oil leakage or excessive

oil usage.

Clogged oil return holes in oil seals. Dismantle and clean oil seals.

Excessive oil level

fluctuation.

High pressure or vacuum in bearing cavity. Measure pressure or vacuum using

manometer (See “Cavity Pressures” under

Bearings).

Check atmospheric vents for obstructions.

Check oil seal gap for uniformity.

DANGER

Hazardous voltage.

Will cause death, serious injury,

electrocution or property damage.

Disconnect all power before working on

this equipment.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 37 38

Comments to this Manuals

No comments

Siemens 680 User Manual Page 13

Comments to this Manuals