Siemens WK14D320GB Instruction Manual download pdf (Page 14)

Special programmes

Fluff Clean

The drum must be empty.

This programme is designed to clean the drying cycle of any fluff

deposits. The washer-dryer uses the flashing symbol

l (Fluff removal

cycle) in the display panel to show that this programme must be run. The

electronic cycle counter is then automatically reset. The

7 (Fluff removal

cycle) symbol goes out after the programme starts.

To run the

Fluff Clean programme, proceed as follows:

 Make sure that the drum is completely empty and close the door.

 Set the programme selector to Fluff Clean.

 Press the Start/Pause button.

You can also run the Fluff Clean programme at any time without

prompting from the appliance.

Rinse + Spin:

An additional rinse cycle with a final spin. If the laundry is to be removed

dripping wet, set the spin speed to $ (Rinse stop) before starting the

programme → page15.

Empty + Spin:

Drain the rinsing water following a programme with $ (Rinse stop)

→ page15.

 Turn the programme selector to Empty + Spin.

 Set the spin speed to $ (Rinse stop).

 Press the Start/Pause button.

Drain and spin at the desired spin speed:

 Turn the programme selector to Empty + Spin.

 Press the Spin rpm button repeatedly until the desired spin speed is

set.

 Press the Start/Pause button.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 35 36

No comments

Siemens WK14D320GB Instruction Manual Page 14