Siemens WD14H421GB Specifications download pdf (Page 18)

en Operating the appliance

18

Reloading the laundry

When the programme has started, the

laundry can be reloaded or taken out as

required.

Select Start/Reload. The washer dryer

checks whether reloading is possible.

Notes

■ If there is a high water level, high

temperature or if the drum is

rotating, the door remains locked

for safety reasons and reloading is

not possible.

If the following is indicated on the

display panel:

A:02 + PAUS ~ Reloading is not

possible. To continue the

programme, select the Start/Reload

button.

« + OPEn are lit ~ Reloading is

possible.

■ Do not open the door until both the

symbols « + OPEn are lit.

■ Do not leave door open for

a prolonged period – water could

run out of the laundry.

■ The reloading function cannot be

activated during the drying phase.

Changing the programme

If you have started the wrong

programme by mistake, you can

change the programme as follows:

1. Select Start/Reload.

2. Select another programme. If

required, adjust the default settings

and/or select additional functions.

3. Select Start/Reload. The new

programme starts from

the beginning.

Interrupting or ending the

programme

For programmes at high temperature:

1. Select Start/Reload.

2. To cool down laundry: select Rinse.

3. Select Start/Reload.

For programmes at low temperature:

1. Select Start/Reload.

2. Select Spin or Drain

3. Select Start/Reload.

For drying programmes:

1. Select Intensive Dry or Gentle Dry.

2. Touch button Dry and set drying

time to 15 minutes.

3. Select Start/Reload.

End of the programme

– 0 – or – – – – (Rinse stop = without

final drain/spin cycle) is indicated in the

display and acoustic signal sounds.

Setting the signal ~ Page 27

If $ (Rinse stop = without final drain/

spin cycle) was selected, press Start/

Reload button to start the final drain/

spin cycle.

Notes

■ The programme continues by

pumping out the water and spinning

the laundry (the standard spin speed

can be changed beforehand).

■ If only the water is to be pumped out,

approx. 1 minute after the

programme starts, touch the Start/

Reload button before the spin cycle

starts, then turn the programme

selector to $ Off. The programme is

interrupted and the door lock is

released. The laundry can be

removed.

■ If hot flashes in the display before

the drying programme ends, the

temperature in the drum is high. The

programme for cooling the drum

runs until the temperature in the

drum has dropped.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 43 44

Comments to this Manuals

No comments