Siemens BS2000/OSD User Manual

Fujitsu Siemens Computers SM2 (BS2000/OSD) *1 Version 15.0B *2 November 2006 Release Notice Copyright (C)

9 3.5 Obsolete functions (and those to be discontinued) - none - 3.6 Incompatibilities SM2: o Measurement program DISK The measurement prog

10

11 3.8 Procedure in the event of errors The contents of the SM2 REP file are always required, as well as the following documentation, depending

12 4 HARDWARE SUPPORT *1 The SM2 V15.0B software monitor supports all hardware compo-nents served by BS2000/OSD-BC V6.0.

Information on this document On April 1, 2009, Fujitsu became the sole owner of Fujitsu Siemens Compu-ters. This new subsidiary of Fujitsu has been re

1 Release Notice SM2 15.0B 1 GENERAL 2 1.1 Ordering 3 1.2 Delivery 3 1.3 Documentation 4 2 SOFTWARE EXTENSIONS 5 3 TECHNICAL INFORMATION

2 1 GENERAL *1 The delivery group SM2 15.0B is part of the delivery unit openSM2 (BS2000/OSD). openSM2 (BS2000/OSD) supplies the user with s

3 Fujitsu Siemens Computers GmbH The use of names, trademarks, etc. in this Release Notice does not entitle readers to assume that these names/d

4 SYSMSP.SM2.150.E PLI1 text file for SM2R1 (English) SYSNRF.SM2.150 Help file for Rep processing SYSPRG.SM2.150.SM2 Prephase for loa

5 2 SOFTWARE EXTENSIONS *1 SM2 V15.0B offers the following extensions and enhancements over the previous version SM2 V14.0B: o The measureme

6 *1 o The measurement program SAMPLIG-DEVICE allows RSC-IOs (on *1 systems with SPARC architecture only) to be recorded for *1 disks

7 3 TECHNICAL INFORMATION 3.1 Resource requirements There are no minimum system equipment restrictions for using SM2, only that required for run

8 o The SYSREP.SM2.150 loader must be generated from the SYSRMS.SM2.150 delivery set with the product RMS. o SM2 expects the following files: S