Siemens TC65 User's Guide download pdf (Page 52)

TC65 JAVA User's Guide

Strictly confidential / Released

TC65 JAVA User's Guide_V05 Page 52 of 90 26.09.2005

In the debug environment the module is connected to a PC via a serial interface. This can be

a USB or an RS232 line. The application can then be edited, built, debugged or run within an

IDE on the PC. When running or debugging the MIDlet under IDE control it is executed on

the module (on-device execution) not on the PC. This can be either debugging mode, where

the midlet execution can still be controlled from the IDE (on-device debugging) or normal

mode, where the midlet is copied to the module and started normally. This ensures that all

interfaces behave the same whether debugging mode is used or not.

10.2 Emulator

The TC65 emulator is part of the SMTK and is used as the controlling entity for on-device

debugging. Before it can be used it must be configured:

The emulator accesses the module with AT commands. In order to do this, it must know the

COM port and bit rate to use. The values are configured in the file

wtk/bin/WM_Debug_config.ini. Set the “Port” and “Baudrate” parameters to the desired

values.

Debugging information between the Debugger (IDE) and the JVM is transferred over an IP

connection. In order to establish this IP connection between the PC and the module the

emulator needs a special Dial-Up-Network (DUN) connection to be configured:

• ISP name: “IP connection for remote debugging”

• Modem: either “Standard 19200 bps Modem” or “TC65 14400 bps Modem”

• Phone number: *88#

• Username and password: any will do, it is recommended that the username and password

be saved for re-usage.

• Disable the “Redial if line dropped” option.

• Enable “Connect automatically”

Make sure that the DUN uses the same COM port and bit rate as the emulator. You can use

any of the three serial interfaces (ASC0, ASC1, USB) to connect with module, but you will

lose the functionality which is normally present on the interface. Because of this loss and

because of its speed it is recommended that the USB interface be used.

If necessary, the IP addresses used for the debug connection can also be changed. This is

done in the file wtk/bin/WM_Debug_config.ini. See the documentation of at^scfg

with

parameter userware/debuginterface for details. Please keep in mind, that the IP address

range 10.x.x.x is not supported for configuration of debugging!

During installation of TC65 SMTK some new programs are installed for handling the

debugging session in conjunction with the IDE. The installation routine of the TC65 SMTK

doesn't change any configuration of an existing firewall on your PC.

In the case, that a firewall is installed on your PC and the local configured and used IP

connection (Dial-Up-Network connection for debugging) is blocked or disturbed by this

firewall, please configure the firewall or the Dial-Up-Network connection manually to accept

the new installed programs and the port or to use another port or contact your local PC

administrator for help.

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 89 90

Comments to this Manuals

No comments

Siemens TC65 User's Guide Page 52

Comments to this Manuals

Related products and manuals for Networking Siemens TC65