Siemens RUGGEDCOM RSG2200 Specifications download pdf (Page 29)

RUGGEDCOM RSG2200

Installation Guide

Chapter 3

Communication Ports

Removing an SFP Optical Port 23

Figure 26: Installing an SFP Optical Port (Typical)

1. SFP Optical Port 2. Metal Bail-Latch

5. Remove the dust cover from the port.

6. Connect a cable to the port and test the connection.

Section 3.3.2

Removing an SFP Optical Port

To remove an SFP optical port, do the following:

CAUTION!

Electrical hazard – risk of damage to equipment. Make sure all electrostatic energy is dissipated before

performing installing or removing components from the device. An electrostatic discharge (ESD) can

cause serious damage to the component once it is outside the chassis.

1. Make sure all potential electrostatic build-up has been properly discharged to prevent electrostatic

discharges (ESD). This can be accomplished by wearing an ESD wrist strap or by touching Earth or the

chassis ground.

2. Disconnect the cable from the port.

3. Swing the metal bail-latch down and pull the port from the module.

Figure 27: Removing an SFP Optical Port (Typical)

1. SFP Optical Port 2. Metal Bail-Latch

4. Store the port in an ESD-safe bag or other suitable ESD-safe environment, free from moisture and stored at

the proper temperature (-40 to 85 °C or -40 to 185 °F).

5. Insert a plug in the empty port opening to prevent the ingress of dust and dirt.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 45 46

No comments

Siemens RUGGEDCOM RSG2200 Specifications Page 29