Siemens E-110-I User Manual

SIEMENS ADSL E-110/E-110-I ETH & USB ComboRouter User Manual Rev:01_040220 2004-02-20 No part of this publication may be reproduce

SIEMENS ADSL E-110_E-110-I user manual Rear PanelRear Panel The following figure illustrates the rear panel of your ADSL Router. ADSL Connects the d

Chapter 2: Installation Chapter 2: Installation Choosing a place for the ADSL Router 1. Place the ADSL Router close to ADSL wall outlet and power o

SIEMENS ADSL E-110_E-110-I user manual ISDN installation If your telephone service is ISDN (SIEMENS ADSL E-110-I), proceed as follows to install your

Chapter 2: Installation USB driver installation Install the USB driver Note: The USB driver is only working on the following operating systems (OS)

SIEMENS ADSL E-110_E-110-I user manual 7. You will be asked whether the PC should be restarted. Click on Close. The PC will be restarted and the foll

Chapter 3: Configuration Chapter 3: Configuration In order to access the Internet through the router, you must check the TCP/IP settings before conf

SIEMENS ADSL E-110_E-110-I user manual 2. Double-click the Network icon. 3. The Network window appears. On the Configuration tab, check out the list

Chapter 3: Configuration 5. On the left side of the windows, highlight Microsoft and then select TCP/IP on the right side. Then click [OK]. 6. W

SIEMENS ADSL E-110_E-110-I user manual 8. When returning to Network window, click [OK]. 9. Windows may ask you for the original Windows installatio

Chapter 3: Configuration For Windows 98 and Windows 98 SE Note: Windows 98 and 98 SE users need the Windows 98 / Windows 98 SE installation CD-ROM

SIEMENS ADSL E-110_E-110-I user manual Safety Notes For Installation • Use only the type of power source indicated on the marking labels. • Use only

SIEMENS ADSL E-110_E-110-I user manual 3. The Network window appears. On the Configuration tab, check out the list of installed network components.

Chapter 3: Configuration 6. When returning to Network window, highlight TCP/IP protocol for your NIC and click [Properties]. 7. On IP Address tab

SIEMENS ADSL E-110_E-110-I user manual 9. Windows may ask you for the original Windows installation disk or additional files. Insert the Windows 95 i

Chapter 3: Configuration For Windows ME 1. Click on the Start menu, point to Settings and click on Control Panel. 2. Double-click the Network icon.

SIEMENS ADSL E-110_E-110-I user manual For Windows NT Note: Windows NT users need the Windows NT installation CD-ROM to complete the installation! 1.

Chapter 3: Configuration 4. Highlight TCP/IP Protocol and click [OK]. 5. Click [Yes] to use DHCP. 6. Insert the Windows NT CD into your CD-ROM d

SIEMENS ADSL E-110_E-110-I user manual 9. Right click on the Network Neighborhood icon on the desktop and select Properties. 10. In the Protocol tab

Chapter 3: Configuration 13. When returning to Network window, click [OK]. Rev:01_040220 21

SIEMENS ADSL E-110_E-110-I user manual For Windows 2000 1. From the Start menu, point to Settings and then click Network and Dial-up Connections. 2.

Chapter 3: Configuration 4. Highlight Protocol and then click [Add]. 5. Click Internet Protocol(TCP/IP) and then click [OK]. 6. When returning to

Contents Content Safety Notes...

SIEMENS ADSL E-110_E-110-I user manual 7. Under the General tab, select Obtain an IP address automatically. Then click [OK]. 8. When prompted to re

Chapter 3: Configuration For Windows XP 1. From the Start menu, point to Control Panel and then click Network and Internet Connections. 2. Click Net

SIEMENS ADSL E-110_E-110-I user manual For Macintosh OS 8.6 and 9.x 1. From the Apple Menu, point to Control Panels and then click TCP/IP.

Chapter 3: Configuration For Macintosh OS 10.x 1. From the Apple Menu, select System Preferences… 2. Click on Network. 3. From the Show pull-down

SIEMENS ADSL E-110_E-110-I user manual 4. On the PPPoE tab, and make sure that the Connect using PPPoE check box is NOT activated. Click Apply Now.

Chapter 3: Configuration Renew IP Address on Client PC There is a chance that your PC does not renew its IP address after the ADSL Router is on line

SIEMENS ADSL E-110_E-110-I user manual For Windows ME 1. Select Run from the Start menu. 2. Type winipcfg in the dialog box and the click [OK]. 3. Wh

Chapter 3: Configuration For Windows 2000 1. From the Start menu, point to Programs > Accessories and then click Command Prompt. 2. Type ipconfi

SIEMENS ADSL E-110_E-110-I user manual Step 2: Quick Configuration via Web browser Your ADSL Router includes a Web-based Configuration Manager, which

Chapter 3: Configuration Advanced Configuration via Web browser Note: Please follow carefully the instructions in the whole chapter in order to be

SIEMENS ADSL E-110_E-110-I user manual Advanced Configuration via Web browser ...

SIEMENS ADSL E-110_E-110-I user manual Main Menu Configuration Manager tasks are grouped info categories which can be accessed by clicking the main me

Chapter 3: Configuration Viewing Basic System Information The System View page displays when you first access the program. The System View table pr

SIEMENS ADSL E-110_E-110-I user manual Quick Configuration The Quick Configuration displays the settings you are most likely to need to change when yo

Chapter 3: Configuration Field Description Use DNS Enable Primary DNS Server / Secondary DNS Server Enter the Primary and Secondary DNS server add

SIEMENS ADSL E-110_E-110-I user manual Sub-Menus For advanced mode, the following sub-menus are available: Lan LAN Config Sets LAN configuration,

Chapter 3: Configuration PPP Configures and displays Point to Point Protocol (PPP) interfaces. The PPP protocol is commonly used between ISPs and

SIEMENS ADSL E-110_E-110-I user manual Chapter 4: Advanced Configuration Configuring IP Routes Most users do not need to define IP routes. You may nee

Chapter 4: Advanced Configuration DHCP Configuration You can configure your network and ADSL Router to use the Dynamic Host Configuration Protoc

SIEMENS ADSL E-110_E-110-I user manual 2. To add an IP address pool, click [Add]. The DHCP Server Pool - Add page displays. Field Description Start

Chapter 4: Advanced Configuration Part 3. Configuring your PCs as DHCP clients For each computer that you want to configure to receive IP inform

Contents Appendix: Specification...

SIEMENS ADSL E-110_E-110-I user manual Configuring DHCP Relay Part 1. Defining the DHCP relay interface(s) 1. Select Lan > DHCP Relay. The DHCP Rel

Chapter 4: Advanced Configuration NAT Configuration This section provides an overview of Network Address Translation (NAT) and instructions for

SIEMENS ADSL E-110_E-110-I user manual The NAT Global Information table contains the following fields: Field Description TCP Idle Timeout(sec) For a

Chapter 4: Advanced Configuration On the NAT Configuration page you can click [Global Stats] to view accumulated data on how many NAT rules have

SIEMENS ADSL E-110_E-110-I user manual Viewing NAT Rules and Rule Statistics To view the NAT Rules currently defined on your system, select Services &

Chapter 4: Advanced Configuration Field Description ALG Type The Application Level Gateway (ALG), if any, that was used to enable this NAT tra

SIEMENS ADSL E-110_E-110-I user manual 2. Define the rule ID and select the interface. 3. In the Local Address From/To fields, type the starting and

Chapter 4: Advanced Configuration 7. If the publicly accessible LAN computer uses a non-standard port number for the type of traffic it receive

SIEMENS ADSL E-110_E-110-I user manual 1. On the NAT Rule - Add page, select FILTER from the Rule Flavor drop-down list. 2. Define the rule ID and s

Chapter 4: Advanced Configuration Bimap rules can be used to provide external access to a LAN device. They do not provide the same level of secu

SIEMENS ADSL E-110_E-110-I user manual RIP Configuration Your ADSL Router can be configured to communicate with other routing devices to determine the

Chapter 4: Advanced Configuration 6. Click [Add]. The new RIP entry will display in the table. 7. Click the Enable radio button to enable the RI

SIEMENS ADSL E-110_E-110-I user manual Firewall, IP Filters and Blocked Protocols Firewall Configuration Configuration Manager provides built-in firew

Chapter 4: Advanced Configuration Field Description Max Half open TCP Conn. Sets the percentage of concurrent IP sessions that can be in the h

SIEMENS ADSL E-110_E-110-I user manual IP Filter Configuration The IP filter feature enables you to create rules that control the forwarding of incomi

Chapter 4: Advanced Configuration Creating IP Filter Rules 1. On the IP Filter Configuration page click [Add]. The IP Filter Rule - Add page dis

SIEMENS ADSL E-110_E-110-I user manual Field Description Log Option When Enabled is selected, a log entry will be created on the system each time th

Chapter 4: Advanced Configuration Field Description Dest Port Port number criteria for the destination computer(s) (i.e., the port number of t

SIEMENS ADSL E-110_E-110-I user manual IP filter rule examples Example 1. Blocking a specific computer on your LAN from using accessing Web servers on

Chapter 4: Advanced Configuration The figure below shows how this rule could be configured: Viewing IP Filter Statistics 1. Select Services >

Before You Use Before You Use The SIEMENS ADSL E-110/E-110-I is an Asymmetric Digital Subscriber Line (ADSL) Router. With the asymmetric technolog

SIEMENS ADSL E-110_E-110-I user manual Managing Current IP Filter Sessions 1. Select Services > IP Filter. The IP Filter Configuration page display

Chapter 4: Advanced Configuration Administration Tasks Changing the System Date and Time The device keeps a record of the current date and time,

SIEMENS ADSL E-110_E-110-I user manual Adding a New User 1. Select Admin > User Config. The User Configuration page displays. 2. Click [Add]. The U

Chapter 4: Advanced Configuration View System Alarms 1. To display the Alarm page, select Admin > Alarm. Each row in the table displays the

SIEMENS ADSL E-110_E-110-I user manual Port Settings The router’s HTTP service (Web Configuration Utility), Telnet service and FTP service are accessi

Chapter 4: Advanced Configuration View DSL Parameters 1. To view configuration parameters and performance statistics for the ADSL Router’s DSL

SIEMENS ADSL E-110_E-110-I user manual 3. From the DSL Status page, you can click [Stats] to display DSL line performance statistics: The DSL Statist

Chapter 5: Connection Mode Chapter 5: Connection Modes The ADSL Router is delivered pre-configured from the factory in Router Mode. This chapter p

SIEMENS ADSL E-110_E-110-I user manual 3. Enter the provided fields as below. Field Description VC Interface Select a VCC interface from the availa

Chapter 5: Connection Mode 5. When confirmation page appears, click [Close]. 6. You will return to the ATM(EoA) Config page and see the newly ad

SIEMENS ADSL E-110_E-110-I user manual Configuration and Management • DSL Forum TR37-compliant auto configuration • SNMPv1 over DSL or Ethernet for

SIEMENS ADSL E-110_E-110-I user manual 5. Commit your changes. Select Admin > Commit & Reboot and click [Save] to save your changes to permanen

Chapter 5: Connection Mode 3. Enter the provided fields as below: Field Description VC Interface Select a VCC interface from the available inte

SIEMENS ADSL E-110_E-110-I user manual Field Description Status Select Start or StartOnData. Start - To establish connection whenever you turn on th

Chapter 5: Connection Mode Router Connection Mode In this deployment environment, we make up a private IP network of 192.168.1.1. NAT function is

SIEMENS ADSL E-110_E-110-I user manual 2. Creating a IPoA interface. 1. Select Wan > IPOA. 2. On the IOoA Configuration page click [Add] to add a n

Chapter 6: Troubleshooting Chapter 6: Troubleshooting This appendix suggests solutions for problems you may encounter in installing or using your

SIEMENS ADSL E-110_E-110-I user manual Problem Troubleshooting Suggestion Cannot access the Configuration Manager program from your browser. Use the

Chapter 7: Glossary Chapter 7: Glossary • ARP (Address Resolution Protocol ) ARP is a TCP/IP protocol for mapping an IP address to a physical mac

SIEMENS ADSL E-110_E-110-I user manual • PVC (Permanent Virtual Circuit) A PVC is a logical point-to-point circuit between customer sites. PVCs are

Appendix: Specification Appendix: Specification Software ADSL Compliance • ANSI T1.413 Issue 2 • ITU G.992.2 Annex A (G.lite) • ITU G.992.1 Annex

Chapter 1: Overview Chapter 1: Overview Physical Outlook Physical Outlook Front Panel The following illustration shows the front panel of the ADSL

SIEMENS ADSL E-110_E-110-I user manual 84 Rev:01_040220 Hardware Interface • One RJ-11 port for ADSL connection • One RJ-45 port for 10/100 Base-T