Siemens M35 or S35 User Manual download pdf (Page 10)

Send a control SMS message from cell phone or Internet, which includes in text:

XXppppINSTRUCTIONVparameter

XX Two capital letters X

pppp Four digits of current PIN in GSM Remote Supervision

INSTRUCTION Key word of the command (no difference with capital or small

letters)

V Space follows

parameter Set-up value*

End of sequence by space or end of SMS message

One SMS can include up to 4 commands. The message then can look like this:

XXppppCOMMAND1Vparameter1VCOMMAND2Vparameter2VCOMMAND3Vparameter3V…

A confirming message is sent to the number the command message came from, this

message includes information about the new set parameter value.

4.1. PIN in GSM Remote Supervision

So as GSM Remote Supervision works correctly it is necessary that PIN on SIM

card corresponds with PIN of GSM gate and is different from 0000. In phone menu

SIM card must be blocked, tm. control of PIN after switch-on must be activated.

If the SIM card is blocked by a PIN code, connect the GB 051 to the mobile phone

only after the PIN in GB 051 was set to the same value – otherwise there is a

great risk of the SIM card getting blocked.

Change of PIN

Command* XXppppPINVnnnn

pppp Four digits of current PIN in GSM Remote Supervision

nnnn Four digits of new PIN

* Space must be between the key word of command “PIN” and value of parameter “nnnn“

GB 051 confirms reception of Command to sender and draws his attention to

necessity of correspondence of PIN in GSM Remote Supervision and on SIM

card of cell phone. At the same time advises of necessity of switching off the

phone by red key. This way new PIN is entered into GSM Remote Supervision

memory and connected cell phone is automatically switched on.

Information about GB 051 reset and change of PIN is sent to INFOSMS number

after action is successfully carried out.

In case the PIN code is the same on the SIM card and in the GB 051 unit and the

SIM is blocked by PIN, then after entering a new PIN into GB 051 the PIN code

on the SIM card will be changed as well.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 23 24

No comments

Siemens M35 or S35 User Manual Page 10