Siemens TC63 Service Manual download pdf (Page 10)

Installation

Siemens Building Technologies

Fire Safety & Security Products 12.2007

5.2 Unit

z Before installing the hardware we strongly recommend that you pre-program the unit. This is done

using a PC or a laptop running the configuration program and using the USB cable supplied.

z If the GSM unit is installed as a backup module, it should be installed at another location than the

panel.

Disconnect the mains and the backup battery.

1. Choose a suitable location for the unit within 1 to 20 meters from the IC60.The

location must be within the secured area.

2. Using the paper template drill 4 holes in the wall to mount the unit.

3. Using four screws, fix the unit to the wall.

4. Connect the unit to the Sintony bus: POS, NEG, CLK, DATA

(see section

3: Connections).

z If external power supply is used to power the IGS6-10, the GND of the bus (from control panel)

must be connected with the GND of the external power supply.

z The 2 wires are connected on the same terminal (NEG).

5. Insert the SIM card into the SIM card housing.

6. Verify that the antenna is connected.

7. Power on the IC60.

8. Connect the backup battery.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 23 24

No comments

Siemens TC63 Service Manual Page 10