Siemens SIMATIC NET CP 343-1 User Manual download pdf (Page 22)

6 Configuring and Programming the CP as a PROFINET IO Device

B3L−22

CP 343-1 Lean for Industrial Ethernet / Manual Part B3L

Release 03/2007

C79000-G8976-C198-04

6.3 Configuration

Configuring the CP as a PROFINET IO device involves the two following activities

in STEP 7:

1. The CP is inserted in a SIMATIC 300 station in HW Config and enabled for

PROFINET IO device mode in the properties dialog.

2. The CP is assigned to a PROFINET IO controller as a PROFINET IO device in

HW Config.

Notice

These two configuration steps can be taken independently in HW Config. In both

steps, make sure that the configured device name for the PROFINET IO device

matches exactly.

6.3.1 Installing the CP and Specifying it as PROFINET IO Device

Follow the steps below in STEP 7 / HW Config:

1. Take the required CP from the hardware catalog and insert the module in the

SIMATIC 300 station.

Figure 6-2 Inserting the CP in a SIMATIC Station in HW Config

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 55 56

No comments

Siemens SIMATIC NET CP 343-1 User Manual Page 22